This document is a guide to Linux network interface statistics.
There are three main sources of interface statistics in Linux:
standard interface statistics based on
protocol-specific statistics; and
driver-defined statistics available via ethtool.
Standard interface statistics¶
There are multiple interfaces to reach the standard statistics. Most commonly used is the ip command from iproute2:
$ ip -s -s link show dev ens4u1u1 6: ens4u1u1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP mode DEFAULT group default qlen 1000 link/ether 48:2a:e3:4c:b1:d1 brd ff:ff:ff:ff:ff:ff RX: bytes packets errors dropped overrun mcast 74327665117 69016965 0 0 0 0 RX errors: length crc frame fifo missed 0 0 0 0 0 TX: bytes packets errors dropped carrier collsns 21405556176 44608960 0 0 0 0 TX errors: aborted fifo window heartbeat transns 0 0 0 0 128 altname enp58s0u1u1
Note that -s has been specified twice to see all members of
If -s is specified once the detailed errors won’t be shown.
ip supports JSON formatting via the -j option.
Some of the interfaces used for configuring devices are also able to report related statistics. For example ethtool interface used to configure pause frames can report corresponding hardware counters:
$ ethtool --include-statistics -a eth0 Pause parameters for eth0: Autonegotiate: on RX: on TX: on Statistics: tx_pause_frames: 1 rx_pause_frames: 1
Driver-defined ethtool statistics can be dumped using ethtool -S $ifc, e.g.:
$ ethtool -S ens4u1u1 NIC statistics: tx_single_collisions: 0 tx_multi_collisions: 0
The historical /proc/net/dev text interface gives access to the list of interfaces as well as their statistics.
Note that even though this interface is using
internally it combines some of the fields.
Each device directory in sysfs contains a statistics directory (e.g.
/sys/class/net/lo/statistics/) with files corresponding to
This simple interface is convenient especially in constrained/embedded
environments without access to tools. However, it’s inefficient when
reading multiple stats as it internally performs a full dump of
and reports only the stat corresponding to the accessed file.
Sysfs files are documented in Documentation/ABI/testing/sysfs-class-net-statistics.
Ethtool IOCTL interface allows drivers to report implementation specific statistics. Historically it has also been used to report statistics for which other APIs did not exist, like per-device-queue statistics, or standard-based statistics (e.g. RFC 2863).
Statistics and their string identifiers are retrieved separately. Identifiers via ETHTOOL_GSTRINGS with string_set set to ETH_SS_STATS, and values via ETHTOOL_GSTATS. User space should use ETHTOOL_GDRVINFO to retrieve the number of statistics (.n_stats).
Some drivers expose extra statistics via debugfs.